Table of Contents
Advertisement
Note:
1. The Flip setting is manually controlled only. If a Preset Position or a point for another
function (ex. Sequence) is set to a position that can only be reached by Flip motion, it
cannot be reached when the Flip function is Off.
2. To tilt the camera within a specific range, such as -10° to +100° or -10° to +190°, set the
tilt angle range on the Tilt Range setting page. If not specified, the default setting is 90°.
3. The Privacy Mask function is automatically disabled when the Image Flip function is
enabled.
Digital Zoom
The digital zoom enables 12 zooming levels (ranging from Off to x12). Select the zoom level from the drop-
down list. Click Set to save the setting.
Speed by Zoom
Enable this function to automatically adjust by internal algorithm the pan/tilt speed when zooming. From
the drop-down list, select On or Off. Click Set to save the setting.
Day/Night Function
The camera uses an IR cut filter to capture a clear image at night time or in low light conditions. From the
drop-down list, select Day to enable, Night to disable, or Auto. In the Auto mode, the internal circuit
automatically chooses when to remove the IR cut filter according to image brightness level. Click Set to
confirm the setting.
ICR Threshold
The ICR Threshold setting switches the sensitivity of the IR cut filter. Select one of the following settings
from the drop-down list:
§
Low
§
Mid
§
High
Click Set to confirm the setting.
Zoom
Select Wide or Tele. Then drag the cursor on the Zoom bar to set the zoom level, which is displayed in the
window (x1..x30).
Focus
Select one of the following settings: Auto, Manual, Near, or Far.
9.5.11 Camera - Misc2
Camera – Misc2 screen on all units except the CP-4221-30x
September 12, 2016
CP-3211/CP-4221 User and Installation Guide
Configuration and Operation
127
Advertisement
Table of Contents
