Table of Contents
Advertisement
Configuration and Operation
If the motion detection function is activated, the following Motion pop-up window appears.
When motion is detected, the signals are displayed in the Motion window shown below.
Motion Detection Settings
Settings for motion detection are as follows:
Sampling pixel interval [1-10] – Select a number from 1-10. The default value is 1. If the value is set
·
as 3, within the detection region, the system will take one sampling pixel for every 3 pixels by
each row and each column (see the figure below).
Detection level [1-100] – Select a number from 1-100. The default level is 40. This sets detection
·
level for each sampling pixel; the smaller the value, the more sensitive it is.
·
Sensitivity level [1-100] – Select a number from 1-100. The default level is 80, which means if 20%
or more sampling pixels are detected differently, the system will detect motion. The bigger the
value, the more sensitive it is. When the value is bigger, the red horizontal line in the motion
detection window will be lowered accordingly.
·
Time interval (sec) [0-7200] – Select a number from 0-7200 (seconds). The default interval is 10.
The value is the interval between each detected motion.
84
Motion Detection Window without Detection
Motion Detection Window with Detection
Pixel Interval Illustration
CP-3211/CP-4221 User and Installation Guide
September 12, 2016
Advertisement
Table of Contents
