Upnp Settings - FLIR Quasar Gen III User And Installation Manual

Note:
You may have to consult with your System Administrator to activate this function.
Traps for SNMP v1/v2/v3
Traps are used by the camera to send messages to a management system for important events or status
changes.
·
Enable traps – Check this box to activate trap reporting.
·
Trap address – Enter the IP address of the management server.
·
Trap community – Enter the community to use when sending a trap message to the
management system. The default value is public.
·
Trap Option
·
Warm start – A warm start SNMP trap signifies that the SNMP device, such as the camera,
performs a software reload.
Click SAVE when finished.
9.3.3.4 UPnP
The System > Network > UPnP screen enables the Universal Plug-and-Play protocol on your network
devices.

UPnP Settings

·
Enable UPnP – If UPnP is enabled and a camera is discovered on the LAN, the icon of the
connected camera appears in My Network Places, allowing direct access, as seen below.
September 7, 2017
UPnP Screen
Direct Access to Camera with UPnP Enabled
CP-6302 User and Installation Guide
Configuration and Operation
47