Table of Contents
Advertisement
Configuration and Operation
On all units, except the CP-4221-300 and CP-4221-301, you can set the following camera parameters on
the Camera-Misc2 page:
§
WDR
§
Auto Calibration
§
Noise Reduction
§
OSD
§
Set Pan Zero
§
TV System
WDR
WDR (Wide Dynamic Range) resolves high contrast or changing light issues in order to enhance the image
quality. It does this by producing a larger amount of details in both the dark and bright areas of the image.
Such scenes combine areas with different lighting conditions, where some areas are very bright and others
are dark. If this function was not used, the image either would be overexposed or too bright in bright areas
and completely dark in dark areas. The WDR function setting is selectable between On or Off. Click Set to
confirm the new settings.
Auto Calibration
Auto Calibration automatically calibrates the camera when a deviation of dome pivot is detected. The
camera constantly aligns itself against vertical and horizontal checkpoints to maintain accurate operation.
From the drop-down list, select On or Off. Click Set to save the setting.
Noise Reduction
The Noise Reduction function analyzes pixel by pixel and frame by frame to eliminate environmental noise
and deliver optimized image quality, especially in low-light conditions. From the drop-down list, select On
or Off. Click Set to confirm the setting.
OSD
Enable the OSD (On-Screen Display) function to display the camera tilt, angle, and zoom ratio settings in
the Live View pane. From the drop-down list, select On or Off. Click Set to save the setting.
128
Camera – Misc2 Screen (all units except CP-4221-301)
CP-3211/CP-4221 User and Installation Guide
September 12, 2016
Advertisement
Table of Contents
