Advertisement
In the DNA Discover List, verify that the camera's status is Authenticated.
c. Change the camera's IP address.
Right-click the camera and select IP Setup.
In the DNA - IP Setup window, clear Use
DHCP and specify the camera's IP
address. You can also specify the Mask
(default: 255.255.255.0) and Gateway.
Then, click Update, wait for
to appear, and then click Close.
3.4 Change Video Format (Optional)
By default, NTSC is the camera's video format.
To change the camera's video format to
PAL using the DNA tool:
a. In the DNA Discover List, right-click the
camera and select Change Video Format.
b. In the Change Video Format window,
select PAL.
c. Click Update, wait for
appear, and then click Close.
For more information about using the DNA tool to configure one or more cameras,
see the DNA User Guide. While the software is open, click the Help icon
4 Install the Camera
Warning
The camera must be installed by qualified personnel and the installation should
conform to all local codes.
Be sure to have the required accessories and tools available and refer to the
camera's installation and user guide as necessary.
4.1 Fit Mounting Hardware
If required, install additional mounting hardware for the camera according to the
instructions for the hardware.
CB-6404/CB-6408 QIG Rev 100
Ok status to
This document does not contain any export-controlled information.
Ok status
.
February 2021
Advertisement
