Remote Cabinet Installation Instructions - Toshiba strata CT Installation & Maintenance Manual

Strata CT Installation

Remote Cabinet Installation Instructions

All instructions apply to both the Base Cabinet and the Remote Expansion Cabinet except
where specifically noted.
1.
2.
3.
4.
H
5.
C
Figure 2-32
2-50
Install cabinets according to the instructions given at the beginning of Chapter 5. Pay
particular attention to wiring and grounding instructions given for Remote Expansion
Cabinets.
If installing a standalone Remote Expansion Cabinet, or the first in a stack, install the
Base Jumper Plug in accordance with
Cabinets in which RRCU cards are installed must be modified to protect the routing of
the cables through the cabinet.
N
Attach the plastic guide to the bracket provided with the RRCU1A card. See
Figure 2-33.
N
Attach the bracket to the inner wall of the cabinet.
Install the RRCU Card
N
Select correct jumper options (see
plugs connect the centre pin to the upper pin (M1, M2). On the Slave side, both
option plugs connect the centre pin to the lower pin (S1, S2).
N
Remove the protective rubber cap from the fiber connector on the ROMS1A
daughterboard. See
Install a BCTC1A top cover on the topmost cabinet (see
Place lid over screws
and slide it to the right.
Remove/Replace Remote Cabinet Cover
Figure 2-2.
Figure 2-34). On the Master side, both option
Figure 2-35.
Figure 2-32).
Top View
5030
Strata CT I&M Manual October 2000