Microphone/Speaker Sensitivity Adjustment (Speakerphones Only); Busy Override And Camp-On Ring Tone Over Handset/Headset Option - Toshiba strata CT Installation & Maintenance Manual

Microphone/Speaker Sensitivity Adjustment
(Speakerphones Only)
➤
To make the 2000 & 2500-series digital telephone models less sensitive to loud surrounding
noise
➤
To reset the sensitivity back to the normal level
H
Busy Override and Camp-on Ring Tone Over Handset/
Headset Option
➤
To send busy override/camp-on ring tones over the handset of the DKT2010-H model
C
➤
To send busy override/camp-on ring tones over the handset/headset of the DKT2510-FSD/
2520-FS/2520-FSD
➤
To block the tone over the handset/headset of the DKT2510-FSD/2520-FS/2520-FSD
Strata CT I&M Manual October 2000
High ambient noise levels may cause the speaker on some digital telephone speakerphone
models to cut off frequently.
➤
Hold down Mic button, then press the Vol L button. The less-sensitive level will be
set after the third flash of the Mic LED.
➤
Hold down the Mic button, then press the Vol
after the third flash of the Mic LED.
Note On 2000 & 2500-series digital telephone speakerphone models that are set for low
sensitivity, the Mic LED flashes at the in-use rate when the speakerphone is used.
When set to normal sensitivity, the Mic LED is on steady when using the
speakerphone.
Using a 2000 & 2500-series digital telephone, the busy override and camp-on ring tones can
be sent over the telephone handset or headset, in addition to the speaker.
1. Loosen the four captive screws on the telephone base
2. Install a strap in the HS-BOV W409 location
3. Reinstall the telephone base.
➤
Hold down the Redial button and press the Vol
➤
Hold down the Redial button and press the Vol
Note
For this to function properly with headsets, make sure the speaker OCA strap or
R607 is cut on the HHEU PCB and the HHEU strap is cut on the telephone.
"Loud Ringing Bell/Headset Upgrade (HHEU)" on Page 5-11 for more
information.)
Station Apparatus
M
button. The normal level will be set
(Figure 5-1), and remove the base.
(see Figure 5-7).
L
button.
M
button.
(See
5-15