Voice Mail System Installation - Toshiba strata CT Installation & Maintenance Manual

H

Voice Mail System Installation

C
Strata CT I&M Manual October 2000
N
Program 35: LEDs 01 and 02 must be On for stations to receive the message waiting
indication (flashing LED) from a VM device. This program also turns On LED 03 for
standard telephone ports that must support standard telephone message waiting lamps.
It is advisable to turn Busy Station Transfer (LED 20) On for all VM/Auto Attendant
ports, and to turn Busy Station Ringing (LED 19) On for all stations that must never be
detected as busy when called by the VM/Auto Attendant port. Also turn LED 03 Off to
disable standard telephone MW signal to VM ports.
N
Program 36: Sets Fixed Call Forward to VM [DN] per customer requirements.
N
Program 37: Sets the transfer recall timer for the VM ports to 11~999 seconds minimum
to allow Call Forward-No Answer to work on VM transferred calls. Station users can
individually set CF-NA ring time from 8~60 seconds.
N
Program 39: Sets the VM-related buttons on the digital and electronic telephones that
will be used to communicate with the VM device.
N
Program *40: Sets VM standard ports into a Distributed Hunt Group (same ports set as
Program 31 VM group).
N
Program 71 (1-3): Sets DDI extensions to ring VM Auto Attendant Ports.
N
Program 71-4: Sets the DDI VM ID code (for Inband Integration only, not SMDI).
N
Program 76: Sets RSIU or RSIS SMDI port.
N
Programs 81~89: Verifies that the ringing assignments to the VM devices are set per
customer requirements.
N
Programs 16, 40, 41, 45~48 and 50~56: Verifies that outgoing Exchange line access is
allowed on VM ports to allow the VM beeper notification feature to operate.
1. Ensure that the RSTU/PSTU PCB is installed in the system per
Slot PCBs.
2. Connect the VM system to the selected RSTU/PSTU standard telephone port. (See
Chapter 4 – Universal Slot PCB
3. Program the Strata CT system for the required VM features. (See
Stratagy DK Voice Messaging Systems" on Page
Mail (Standard Telephone Port) Programming" on Page
4. Perform additional VM system programming as applicable (See customer-supplied
installation/programming manuals).
Note Some VM devices may ring trip when called; in this case, set the square-wave ring
voltage jumper to L (low position) on the PSTU2 PCB connected to the VM device.
This is not necessary on RSTU PCBs because they have a sine-wave ring generator.
Wiring)
6-41, paragraph 3 and
6-43.)
Peripheral Installation
Chapter 3 – Universal
"Toshiba Stratagy &
"General Voice
6-45