Windows Operator's Console (Woc) Programming - Toshiba strata CT Installation & Maintenance Manual

Station Apparatus
Notes

Windows Operator's Console (WOC) Programming

Program 03: Code 51 assigns the RATU PCB attendant console cabinet slot number.
Important!
H
Program 15: If the attendant console is used to set-up trunk-to-trunk (two Exchange-line or
tandem) connections with loop start lines, set Program 15-5 appropriately; if the Exchange
C
line sends the AR-Hold signal, set 15-0 and 15-3 to Detect. If the Exchange line does not
send the AR signal, set 15-0 and 15-3 to Ignore. Loop start trunk-to-trunk calls remain on
attendant hold loops only if AR-Ignore is set.
Program 58
N
N
N
N
Program 59: Assigns attendant console Flexible Buttons (Keys) for each console.
5-30
Do not cut HEADSET jumper unless you are connecting two headsets.
G
Cut CARBON jumpers if a carbon handset is connected to the RATHC handset
G
cradle.
"REC OUT" can be used to monitor or record the attendant console talkpath. Both
G
the attendant and connected party will be monitored or recorded. The record level
output from the attendant handset or headset is approximately 3 dB below the
connected party record level. Use a 1/8" mini audio jack.
"AUX IN" can be used to send audio to the attendant and connected party. The audio
G
level to the attendant is approximately 10 dB below the audio level sent to the
connected party. Audio sent to the outside party is limited to–15 dBv (CO Tip/Ring).
Use a 1/8" mini audio jack.
See Figure 4-9 in Chapter 4 – Universal Slot PCB Wiring
G
information.
The RATU PCB takes up four station ports in software; each attendant
console will be assigned one of the ports in consecutive order. Toshiba
recommends installing the RATU PCB in the next highest slot number
following the last station PCB installed–do not skip slots. The first port
number will be the next consecutive port number following the last station
port installed.
58-1: Sets the attendant console overflow time for each console.
58-2: Sets the console display for EL or CRT (EGA) and enables or disables console
call waiting tone for each console. (Not used for the PC attendant console).
58-4: Sets the console Answer key priority for each console.
58-5: Sets the console overflow destination for each console.
for RATI cable wiring
Strata CT I&M Manual October 2000