Toshiba strata CT Installation & Maintenance Manual page 223

H
C
Strata CT I&M Manual October 2000
Note If PIOU, PIOUS or RSIU/RSIS are assigned as SMDR simultaneously in
programming, RSIU/RSIS will operate as SMDR – not PIOU, PIOUS. A display of
the customer database
SMDR RS-232 port by running Program 97.
To program SMDR, use Program 60. The SMDR port is active only on the PIOU or PIOUS
with the lowest Program 03 code (41, 42, or 43), or the RSIU or RSIS Port programmed with
code x2 in Program 76-1.
SMDR sends out special names for the following types of calls:
N
MSS – Prints on DISA and External Call Forward calls to stations. MSS prints only on
DISA calls that are answered after the threshold time (set in Program 60-2). If the call is
answered before the threshold time, the call will register as a normal incoming call and
the MSS/transfer portion of the call will not print out.
Note The call threshold time – the length of time that a call must be in progress before it
is registered by SMDR – can be set for either 1.0 or 10 seconds in Program 60-2.
N
MODEM – Prints on calls to the RMDS or IMDU remote maintenance modem (Station
#19).
N
DISA – Prints on DISA and External Call Forward calls in which Exchange lines are
accessed for trunk-to-trunk outside calling.
Figure 6-20, "SMDR Output Breakdown"
describes the contents of each column. The following examples show call record samples and
describe the sequence of events that generated the call records.
If a subaddress for a call is received or sent on an ISDN call, it is included in the SMDR.
Subaddresses may/may not be received/sent on all ISDN calls
(Figure 6-22 on Page 6-41) can also be printed using the
shows a breakdown of the SMDR printout and
Peripheral Installation
6-35