Rptu Installation - Toshiba strata CT Installation & Maintenance Manual

ISDN Interfaces
Strata CT Slot Assignments
RPTU PCB Cabinet Slot Configuration
Table 10-2
PRI Lines Needed
1~30
31~40
61~90
91~120
121~150
H
151~180
1.
RPTU PCBs do not have to be installed in the order shown in this table. Example: If only one RPTU is needed, it can
be installed in any RPTU slot shown in the table so long as the slot is supported by the installed processor.
C

RPTU Installation

Before installing a RPTU PCB into a CT system, a number of system programs should be
run. This enables the RPTU to function immediately upon insertion. It is recommended that
you run these programs in the order listed in the Strata CT Programming Manual (refer to the
ISDN section) before beginning installation.
➤
To install an RPTU PCB
1.
2.
3.
10-4
Slots Needed
2
2
2
Second through fifth cabinets
2
2
2
Turn the CT system power Off.
Insert the RPTU (component side facing right) into the appropriate slot (see "Slot
Assignments" on "Strata CT Slot Assignments"
pressure to ensure proper seating of connectors.
After installing the RPTU, gently pull the PCB outward. If the connectors are properly
seated, a slight resistance is felt.
1
RPTU PCBs Needed
Base Cabinet
1st
2nd
3rd
1st
2nd
3rd
on Page
Strata CT I&M Manual October 2000
RPTU cabinet slot placement
S103-RPTU
S104-vacant
S105-RPTU
S106-vacant
S107-RPTU
S108-vacant
S_01-RPTU
S_02-vacant
S_03-RPTU
S_04-vacan
S_05-RPTU
S_06-vacant
10-3) and apply firm, even
1