Toshiba strata CT Installation & Maintenance Manual page 32

Strata CT Configuration
RRCU PCB/ Remote Cabinet Configuration
Table 1-11
RRCU PCBs
Needed in
Base Cabinet
1
2
3
4
N
Remote Cabinet Data Cables and Connectors
Table 1-12
Data Cables
BDCL1A-MS1
H
BDCL1A-M2
BDCL1A-S2
X=applies to connector
4. ISDN PRI Digital Line PCBs
RPTU must be placed in designated slots as shown in
C provide 30 ISDN PRI lines. The RPTU slot provides 30 PRI lines.
RPTU PCB Cabinet Slot Configuration
Table 1-13
PRI Lines
Needed
1~30
31~60
61~90
1~30
31~60
61~90
1.
RPTU PCBs do not have to be installed in the order shown in this table. Example: If only one RPTU is needed, it can be
installed in any RPTU slot shown in the table so long as the slot is supported by the installed processor.
2 The slot occupied by RPTU supports 30 channels; the slot adjacent to RPTU must be vacant.
1-18
Remote Cabinet Configuration
1 or 2 Remote Cabinets in one location
2 to 4 Remote Cabinets in two locations or 3 to 4 Remote
cabinets in one location.
3 cabinets if cabinets are in separate remote locations.
4 cabinets if cabinets are in separate remote locations.
Cables are provided according to the connectors on the RRCU card to which they are
attached. See Table 1-12
M1
Slots
RPTU PCBs Needed
Needed
2
4
6
Second through fifth cabinets
2
4
6
for connector information.
RRCU Connectors
S1
X X
Table
1
Base Cabinet
1
2
3
1
2
3
RRCU PCBs Needed at
Remote Location (s)
1
2
3
4
M2
X
1-13. The RPTU PCB can
RPTU cabinet slot placement
S103-RPTU
S105-RPTU
S107-RPTU
S_01-RPTU
S_03-RPTU
S_05-RPTU
Strata CT I&M Manual October 2000
S2
X
1