Customer-Supplied Voice Mail Messaging Systems; General Voice Mail (Standard Telephone Port) Programming - Toshiba strata CT Installation & Maintenance Manual

Customer-supplied Voice Mail Messaging Systems

General Voice Mail (Standard Telephone Port) Programming

H
VM Groups
C
Message Waiting (MW) Set/Cancel
No Conference VM
Privacy Override Deny
End-to-End Signalling
Strata CT I&M Manual October 2000
Recall (B) Tone
Stations send a recall (B) tone to Stratagy whenever Stratagy answers a transfer (camp-on)
recall from stations that did not answer a Stratagy blind transfer. (The B tone notifies Stratagy
that the call is a recall and not a new call, allowing Stratagy to respond with the appropriate
greeting.) For this feature to operate, RSTU or PSTU voice mail ports must have LEDs 19
and 20 turned On in Program 31.
See "General Voice Mail (Standard Telephone Port) Programming" on Page 6-43
more information.
Strata CT systems are designed to support a wide range of customer-supplied voice mail
messaging systems. Depending on the voice mail system used, some of the features available
with Toshiba Stratagy (See
Page 6-41) may be available with the customer-supplied system.
Voice mail (VM) RSTU or PSTU port programming is accomplished using Programs 31 and
10-2. (See Strata CT Programming Manual for more details.) VM programming features are
as follows:l
This feature groups VM RSTU or PSTU ports together so that message waiting set/cancel
signals appear to originate from the lowest port in the VM group. All VM ports connected to
a particular VM machine should be set in the same VM group (Program 31, LEDs 05~08).
The same ports set in the Program 31 VM group should also be set in the designated VM
Distributed Hunt Group in Program *40.
If the VM machine has the ability to dial a code and the appropriate station numbers to set or
cancel the message waiting LEDs on digital and electronic telephones, you can use Program
10-2, LED 04 to instruct the VM machine to set or cancel a MW LED. See the Strata CT
Programming Manual for more information.
Only dial codes #63 and #64 are set in the VM device configuration; the VM
Note
device dials the station number automatically to set/cancel the MW LED.
Prevents undesired three-party connections during VM call transfers. All VM ports should be
set for No Conference (Program 31, LED 09).
Prevents stations from overriding (breaking in) in-progress VM calls (Program 31, LED 18).
Enables VM port DTMF operation. All VM ports should be set for end-to-end signalling
(Program 31, LED 17).
Note The BRCS must be installed on the Processor to enable End-to-End Signalling.
"Toshiba Stratagy & Stratagy DK Voice Messaging Systems" on
Peripheral Installation
below for
6-43