Cabinet Floor Mounting - Toshiba strata CT Installation & Maintenance Manual

Strata CT Installation

Cabinet Floor Mounting

The part numbers and descriptions of the floor mounting hardware are shown in
Floor Mount Hardware
Table 2-6
Option
BFIF
Floor Mounting One or Two Cabinets
1.
2.
H
3.
4.
5.
C
6.
7.
8.
9.
Floor Mounting Three or More Cabinets
This section shows you how to mount three or more cabinets to a concrete, wood or computer
room floor. Use the General Steps for all of these methods first, then the specific steps that
follow for each method.
1.
2.
3.
2-26
Floor mount fixture kit is required when floor mounting two or more Strata CT
cabinets.
Provides two metal stands for mounting any number of Strata CT cabinets on
floor. Three pairs or wall brackets (RWBF) are supplied with BFIF to use when
mounting three or more Strata CT cabinets on floor. The wall brackets are
needed to secure floor-mounted systems to the wall for safety purposes.
Remove front, side, and top covers from cabinet(s)
locating parts from all cabinet back covers using a Phillips screwdriver.
Make sure that cabinet power supplies (BPSU672A) are installed per
Supply" on Page 2-6.
If installing just one or two cabinets, install the BFIF fixtures on each side of the bottom
of the cabinet (Figure 2-15) and place the cabinet where it should be installed.
Set the bottom cabinet on the floor or mount surface, then set the top cabinet on the
bottom cabinet.
Fasten the two cabinets together with the four screws provided: (two screws at front "A"
and two at back "B" of cabinet. Place cabinet where it should be installed.
Connect the Expansion Cabinet data cable to the "CAB. 2" data cable connector on the
Base Cabinet (Figures 2-8
...or if installing a Remote Expansion Cabinet: see details in
Installation Instructions" on Page
Install ground wiring, AC and reserve power cabling, and PCB cabling per the
"Recommended Installation Sequence" on Page
Fill out cabinet/slot identification labels on cabinet(s)
Reinstall covers on to cabinets
Make sure that cabinet power supplies (BPSU672A) are installed per
Supply" on Page 2-6.
Remove front, side, and top covers from all cabinets
Remove plastic locating parts from all cabinet back covers using Phillips screwdriver
(Figure 2-3).
Install a floor fixture (BFIF) on each side of the bottom cabinet. (Make sure that the
fixture is inside of the cabinet edge. For Steps 3~10, see
Description
and 2-11).
2-50.
2-5.
(Figure 2-4).
Strata CT I&M Manual October 2000
Table
(Figure 2-4). Remove plastic
"Install Power
"Remote Cabinet
(Figure 2-7).
"Install Power
(Figure 2-4).
Figures 2-15~2-19.
2-6.