GE Multilink ML810 Instruction Manual page 261

CHAPTER 16: SNMP
MULTILINK ML810 MANAGED EDGE SWITCH – INSTRUCTION MANUAL
CONFIGURING SNMP THROUGH THE COMMAND LINE INTERFACE
Example 16-1: Configuring SNMP
ML810#
set snmp type=v1
SNMP version support is set to "v1"
ML810#
show snmp
SNMP CONFIGURATION INFORMATION
------------------------------
SNMP Get Community Name : public
SNMP Set Community Name : private
SNMP Trap Community Name : public
AuthenTrapsEnableFlag : disabled
SNMP Access Status : enabled
SNMP MANAGERS INFO
------------------
SNMP TRAP STATIONS INFO
-----------------------
ML810#
set snmp type=all
SNMP version support is set to "v1, v2c, v3"
ML810#
show snmp
SNMP v3 Configuration Information
=============================
System Name : ML810
System Location : Markham, ON
System Contact : multilin.tech@ge.com
Authentication Trap : Disabled
Default Trap Comm. : public
V3 Engine ID : Multi_Switch_Engine
ML810#
snmpv3
ML810(snmpv3)##
setvar sysname=ML810 syscontact=admin syslocation=
ML810(snmpv3)#
quickcfg
This will enable default VACM.
Do you wish to proceed? ['Y' or 'N' ] Y
Quick configuration done, default VACM enabled
ML810(snmpv3)##
engineid string=Multi_1200
Engine ID is set successfully
ML810(snmpv3)##
authtrap enable
Authentication trap status is set successfully
ML810(snmpv3)##
show-authtrap
Authentication Trap Status: Enabled
ML810(snmpv3)##
deftrap community=mysecret
Default trap community is set successfully
ML810(snmpv3)##
show-deftrap
16–7