GE Multilink ML810 Instruction Manual page 152

PORT SETUP
Note
NOTE
Example 9-1: Port setup
ML810#
ML810(device)##
ML810(device)##
ML810(device)##
Keys: E = Enable
Port Name
-------------------------------------------------------------------------------
1 A1
2 A2
3 JohnDoe E
4 JaneDoe E
5 A5
6 A6
7 A7
9–4
In Example 9-1, ports 3 and 4 are given specific names. Ports 1 and 5 are active, as shown
by the link status. Port 5 is set to 100 Mbps, and all other ports are set to 10 Mbps. All ports
are set to auto sensing (speed).
The port and
speed duplex
The setting defaults to auto and senses speed and negotiates with the port at the
speed
other end of the link for data transfer operation (half-duplex or full-duplex). The "auto"
speed detection uses the IEEE 802.3u auto negotiation standard for 100Base-T networks. If
the other device does not comply with the 802.3u standard, then the port configuration on
the switch must be manually set to match the port configuration on the other device.
Possible port setting combinations for copper ports are:
• 10HDx: 10 Mbps, half-duplex
• 10FDx: 10 Mbps, full-duplex
• 100HDx: 100 Mbps, half-duplex
• 100FDx: 100 Mbps, full-duplex
Possible port settings for 100FX (fiber) ports are:
• 100FDx (default): 100 Mbps, full-duplex
• 100HDx: 100 Mbps, half-duplex
To change the port speed on a transceiver port, it is required to reboot the switch.
device
setport port=3 name=JohnDoe
setport port=4 name=JaneDoe
show port
D = Disable
H = Half Duplex F = Full Duplex
M = Multiple VLAN's NA = Not Applicable
LI = Listening LE = Learning
F = Forwarding B = Blocking
Control Dplx Media Link Speed Part Auto VlanID GVRP STP
E H 10Tx UP 10
E H 10Tx DOWN 10
H 10Tx DOWN 10
H 10Tx DOWN 10
E F 100Tx UP 100 No E
E H 10Tx DOWN 10
E H 10Tx DOWN 10
CHAPTER 9: PORT MIRRORING AND SETUP
(data transfer operation) settings are summarized below.
No E 1 - -
No E 1 - -
No E 1 - -
No E 1 - -
1 - -
No E 1 - -
No E 1 - -
MULTILINK ML810 MANAGED EDGE SWITCH – INSTRUCTION MANUAL