GE Multilink ML810 Instruction Manual page 205

CHAPTER 12: SPANNING TREE PROTOCOL (STP)
Configuring STP parameters (continued)
ML810(stp)##show stp ports
STP Port Configuration
-------------------------------------------------------------------------------
Port# Type Priority Path Cost State
-------------------------------------------------------------------------------
01 TP(10/100) 128
02 TP(10/100) 128
03 100MB Fiber 128
04 100MB Fiber 128
05 100MB Fiber 128
06 100MB Fiber 128
07 TP(10/100) 128
ML810(stp)##priority value=15535
Successfully set the bridge priority
ML810(stp)##show stp config
STP CONFIGURATION
-----------------
Spanning Tree Enabled(Global) : YES
Spanning Tree Enabled(Ports) : YES, 1,2,3,4,5,6,7
Protocol : Normal STP
Bridge ID : 3c:af:00:20:06:2b:e1:54
Bridge Priority
Bridge Forward Delay
Bridge Hello Time
Bridge Max Age
Root Port : 0
Root Path Cost
Designated Root
Designated Root Priority
Root Bridge Forward Delay
Root Bridge Hello Time
Root Bridge Max Age
MULTILINK ML810 MANAGED EDGE SWITCH – INSTRUCTION MANUAL
Des. Bridge
100 Forwarding 80:00:00:20:06:2b:e1:54 80:01
19 Forwarding 80:00:00:20:06:2b:e1:54 80:02
100 Disabled 80:00:00:20:06:2b:e1:54 80:03
100 Disabled 80:00:00:20:06:2b:e1:54 80:04
100 Disabled 80:00:00:20:06:2b:e1:54 80:05
100 Disabled 80:00:00:20:06:2b:e1:54 80:06
100 Disabled 80:00:00:20:06:2b:e1:54 80:07
: 15535
: 15
: 2
: 20
: 0
: 3c:af:00:20:06:2b:e1:54
: 15535
: 15
: 2
: 20
Des. Port
Ports that have connected devices
now participate in STP.
STP is now enabled. Note the default
values for the discussed variables.
CONFIGURING STP
12–9