Configuring Tacacs+ Through The Command Line Interface; Commands; Example - GE Multilink ML810 Instruction Manual

CONFIGURING TACACS+ THROUGH THE COMMAND LINE INTERFACE

8.2.1

Commands

8.2.2

Example

8–4
8.2 Configuring TACACS+ through the Command Line
Interface
There are several commands to configure TACACS+.
The command displays the status of TACACS or servers configured as
show tacplus
TACACS+ servers:
show tacplus <status|servers>
The and
tacplus enable
authentication:
tacplus <enable|disable>
The command creates a list of up to five TACACS+ servers:
tacserver
tacserver <add|delete> id=<num>
[ip=<ip-addr>] [port=<tcp-port>] [encrypt=<enable|disable>] [key=<string>]
The argument is mandatory and specifies whether to add or delete a
<add|delete>
TACACS+ server. The argument is mandatory and sets the order to poll the TACACS+
id
servers for authentication. The
address of the TACACS+ server. The
the TCP port number on which the server is listening. The
disables packet encryption and is mandatory for deleting. The
secret shared key string must be supplied when encryption is enabled.
Example 8-1 below, illustrates how to configure TACACS+.
CHAPTER 8: ACCESS USING TACACS+
commands enable or disable TACACS
tacplus disable
argument is mandatory for adding and defines the IP
ip
argument is mandatory for deleting and defines
port
MULTILINK ML810 MANAGED EDGE SWITCH – INSTRUCTION MANUAL
argument enables or
encrypt
argument requires the
key