GE Multilink ML810 Instruction Manual page 222

CONFIGURING RSTP THROUGH THE COMMAND LINE INTERFACE
13–14
The syntax for the romode command on RSTP is shown below.
romode add port=<port|list|range>
romode del port=<port|list|range>
romode <enable|disable>
romode show
The sequence of commands for enabling ring-only mode is shown in the following
example:
Example 13-5: Configuring smart RSTP, ring-only mode
ML810# rstp
ML810(rstp)##rstp enable
Successfully set the RSTP status
ML810(rstp)##romode show
RO-MODE status : Disabled
RO-MODE set on ports : NONE
ML810(rstp)##romode add port=1,2
Added Ports: 1,2
ML810(rstp)##romode enable
RSTP Ring Only Mode Enabled.
ML810(rstp)##romode show
RO-MODE status : Enabled
RO-MODE set on ports : 1,2
ML810(rstp)##romode disable
RSTP Ring Only Mode Disabled.
ML810(rstp)##romode show
CHAPTER 13: RAPID SPANNING TREE PROTOCOL
MULTILINK ML810 MANAGED EDGE SWITCH – INSTRUCTION MANUAL