Configuring Tag Vlans Through The Command Line Interface; Description; Commands - GE Multilink ML810 Instruction Manual

CONFIGURING TAG VLANS THROUGH THE COMMAND LINE INTERFACE

10.4.1 Description

10.4.2 Commands

10–12
10.4 Configuring Tag VLANs through the Command Line
Interface
The VLAN information needs to be propagated on to other switches when multiple
switches are connected on a network. In these situations it is best to use tag-based VLANs.
The command for setting Tag VLANs has the following parameters. The
set-port
parameter sets the default VLAN id (termed PVID in previous versions). The
default id
default VLAN id is the VLAN id assigned to the untagged packets received on that port. For
the MultiLink ML810 Managed Edge Switch, the default VLAN id is 1
set-port port=<number|list|range>
default id=<number>
The parameter enables or disables the VLAN filtering function. When enabled, the
filter
switch will drop the packets coming in through a port if the port is not a member of the
VLAN. For example, if port 1 is a member of VLANs 10, 20 and 30, if a packet with VLAN id
40 arrives at port 1 it will be dropped.
set-port port=<number|list|range>
filter status=<enable|disable>
The and
tagging id status
will be tagged or untagged. This definition is on a per VLAN basis. For example, the
command
set-port port=1 tagging id=10 status=tagged
switch to tag all packets going out of port 1 to belong to VLAN 10.
set-port port=<number|list|range>
tagging id=<number> status=<tagged|untagged>
The parameter adds the specified port(s) to the specified VLAN id. This parameter
join id
works with active or pending VLANs.
set-port port=<number|list|range>
join id=<number>
The parameter releases a specific port from a VLAN. For example if port 1
leave id
belongs to VLAN 10, 20, 30, 40 the command set-port port=1 leave id=40 makes port 1
belong to VLAN 10, 20, 30, dropping VLAN 40.
set-port port=<number|list|range>
leave id=<number>
The command lists all parameters related to tag VLAN for the list of ports. If
show-port
the parameter is omitted, it will display all ports.
port
show-port [port=<port|list|range>]
To move Management Control on any VLAN:
add id=<vlan Id> [name=<vlan name>] port=<number|list|range>
[Forbid=<number|list|range>][<mgt|nomgt>]
To enable or disable Management Control on any VLAN:
edit id=<vlan Id>[name=<vlan name>][port=<number|list|range>[<mgt|nomgt>]
parameters define whether the outgoing packets from a port
MULTILINK ML810 MANAGED EDGE SWITCH – INSTRUCTION MANUAL
CHAPTER 10: VLAN
will instruct the