Command Reference; Main Commands - GE Multilink ML810 Instruction Manual

COMMAND REFERENCE

17.8.1 Main Commands

17–14
17.8 Command Reference
The main commands can be categorized as show commands, set commands, and
context-less commands. The show commands are listed below.
•
show active-snmp
•
show active-stp
•
show active-vlan
•
show address-table
• : displays the address table age limit
show age
• : displays the arp details
show arp
• : displays the current bootmode value
show bootmode
•
show broadcast-protect
• : displays the saved configuration as a whole or by module
show config
• : displays console serial link settings
show console
• : displays system date
show date
• : displays the configured daylight savings settings
show daylight
• : displays the gateway of the system
show gateway
• : displays the GVRP parameters
show gvrp
• : displays the host table for FTP users
show host
• : displays the IGMP parameters
show igmp
•
show interfaces
• : displays the system IP address
show ip
•
show ip-access
• : displays the IP configuration
show ipconfig
•
show lacp
• : displays the Link-Loss-Learn parameters
show lll
• : displays log information
show log
• : displays the current event log size
show logsize
• : displays the system MAC address
show mac
• : displays Modbus settings
show modbus
• : displays the module information
show modules
• : displays the port information
show port
•
show port-mirror
•
show port-security
• : displays condition of power supplies, in redundant power supply
show power
switches only
• : displays the QOS settings
show qos
• : displays the rmon configuration parameters
show rmon
• : displays the setup parameters of the system
show setup
CHAPTER 17: MISCELLANEOUS COMMANDS
: displays currently active SNMP support
: displays currently active STP
: displays currently active VLAN
: displays address table parameters
: displays broadcast storm protection parameters
: display the interface information
: displays the IP address access list
: displays the port mirroring parameters
: displays the port security configuration parameters
MULTILINK ML810 MANAGED EDGE SWITCH – INSTRUCTION MANUAL