GE Multilink ML810 Instruction Manual page 215

Managed edge switch
Hide thumbs Also See for Multilink ML810:
Table of Contents

Advertisement

CHAPTER 13: RAPID SPANNING TREE PROTOCOL
Example 13-3: RSTP information from a network with multiple switches
ML810(rstp)##show stp ports
RSTP Port Configuration
-------------------------------------------------------------------------------
Port# Type
Priority Path Cost State
-------------------------------------------------------------------------------
01 TP(10/100) 128 200000
02 TP(10/100) 128 2000000
03 100MB Fiber 128 200000
04 100MB Fiber 128 200000
MULTILINK ML810 MANAGED EDGE SWITCH – INSTRUCTION MANUAL
Des. Bridge
Forwarding 80:00:00:20:06:30:00:01 00:01
Disabled
Disabled
Disabled
Table 13–1: Path cost as defined in IEEE 802.1d / 802.1w
Port type
10 Mbps
100 Mbps
1 Gbps
10 Gbps
• State: Indicates the STP state of individual ports. Values can be Listening, Learning,
Forwarding, Blocking and Disabled.
• Des. Bridge: This is the port's designated root bridge
• Des. Port: This is the port's designated root port
Another example of the same command, from a larger network with several switches is
shown in Example 13-3. Note the
manager level prompt or from RSTP configuration state as shown in the screen captures
earlier
In this example, ports 9 and 10 have a path cost of 20000 and are the least cost paths.
These ports are connected to other switches and the ports are enabled as forwarding
ports. Ports 6 and 7 are also connected to other switches. From the state column, it
indicates that port 7 is in a standby state as that port is discarding all traffic.
More CLI commands associated with RSTP in the RSTP configuration mode are shown
below. The
forceversion
forceversion <stp|rstp>
The
show-forceversion
show-forceversion
The
command displays the values of the timers set for RSTP.
show-timers
show-timers
CONFIGURING RSTP THROUGH THE COMMAND LINE INTERFACE
Des. Port
00:02
00:03
00:04
STP path cost
100
19
4
2
command can be executed from the
show stp ports
command sets the STP or RSTP compatibility mode.
command displays the current forced version.
RSTP path cost
2000000
200000
20000
2000
13–7

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents