Example - GE Multilink ML810 Instruction Manual

CONFIGURING IGMP THROUGH THE COMMAND LINE INTERFACE

15.2.2 Example

15–8
The command sets the query response interval representing the maximum
set-qri
amount of time that can elapse between when the querier router sends a host-query
message and when it receives a response from a host. The range can be from 2 to 270
seconds, with a default of 10. Restrictions apply to the maximum value because of an
internal calculation that is dependent on the value of the query interval.
set-qri interval=<value>
The following example shows how to configure IGMP.
Example 15-1: Configuring IGMP
ML810(igmp)##
set-port port=2-4 mode=forward
Port mode is set.
ML810(igmp)##
show-port
---------------------
Port | Mode
---------------------
1 | Auto
2 | Forwarding
3 | Forwarding
4 | Forwarding
5 | Auto
6 | Auto
7 | Auto
ML810(igmp)##
show-router
RouterIp PortNo Timer
---------------------------------
10.21.1.250 1
(continued on next page)
25
MULTILINK ML810 MANAGED EDGE SWITCH – INSTRUCTION MANUAL
CHAPTER 15: IGMP