GE Multilink ML810 Instruction Manual page 181

CHAPTER 10: VLAN
Converting Port VLAN to Tag VLAN (continued)
-----------------------------------------------
PORT | MODE |
-----------------------------------------------
1 | UNTAGGED |
2 | UNTAGGED |
6 | UNTAGGED |
7 | UNTAGGED |
VLAN ID: 10
Name : engineering
Status : Active
-----------------------------------------------
PORT | MODE |
-----------------------------------------------
3 | UNTAGGED |
4 | UNTAGGED |
5 | UNTAGGED |
VLAN ID: 20
Name : sales
Status : Active
-----------------------------------------------
PORT | MODE |
-----------------------------------------------
3 | UNTAGGED |
4 | UNTAGGED |
5 | UNTAGGED |
VLAN ID: 30
Name : marketing
Status : Active
-----------------------------------------------
PORT | MODE |
-----------------------------------------------
3 | UNTAGGED |
4 | UNTAGGED |
5 | UNTAGGED |
ML810(tag-vlan)##set-port port=3-5 tagging id=10 status=tagged
Port tagging enabled
ML810(tag-vlan)##set-port port=3-5 tagging id=20 status=tagged
Port tagging enabled
ML810(tag-vlan)##set-port port=3-5 tagging id=30 status=tagged
Port tagging enabled
ML810(tag-vlan)##show vlan type=tag
VLAN ID: 1
Name : Default VLAN
Status : Active
(continued on next page)
MULTILINK ML810 MANAGED EDGE SWITCH – INSTRUCTION MANUAL
CONFIGURING TAG VLANS THROUGH THE COMMAND LINE INTERFACE
STATUS
UP
DOWN
DOWN
UP
STATUS
DOWN
DOWN
DOWN
STATUS
DOWN
DOWN
DOWN
STATUS
DOWN
DOWN
DOWN
Enable filtering on the ports required. The
software will prompt to ensure that
connectivity is not disrupted.
VLANs are now active. However, as the
packet traverses VLANs, the packet should
be tagged. This is enabled next.
10–17