GE Multilink ML810 Instruction Manual page 134

CONFIGURING 802.1X THROUGH THE COMMAND LINE INTERFACE
Setting port control parameters (continued)
ML810(auth)##
reauth port=1 status=enable period=300
Successfully set re-authentication parameter(s)
ML810(auth)##
shoW-port reauth
Port Reauth Status Reauth Period (sec.)
=========================================
1 Enabled 300
2 Enabled 3600
3 Enabled 3600
4 Enabled 3600
5 Enabled 3600
6 Enabled 3600
ML810(auth)##
show-stats port=3
Port 3 Authentication Counters
authEntersConnecting
authEapLogoffsWhileConnecting
authEntersAuthenticating
authAuthSuccessesWhileAuthenticating : 2
authAuthTimeoutsWhileAuthenticating : 0
authAuthFailWhileAuthenticating
authAuthReauthsWhileAuthenticating : 0
authAuthEapStartsWhileAuthenticating : 1
authAuthEapLogoffWhileAuthenticating : 0
authAuthReauthsWhileAuthenticated
authAuthEapStartsWhileAuthenticated : 0
authAuthEapLogoffWhileAuthenticated : 0
backendResponses
backendAccessChallenges
backendOtherRequestsToSupplicant
backendNonNakResponsesFromSupplicant : 2
backendAuthSuccesses
backendAuthFails
ML810(auth)##
trigger-reauth port=3
Successfully triggered re-authentication
ML810(auth)##
7–8
: 3
: 0
: 3
: 0
: 0
: 5
: 2
: 0
: 2
: 0
CHAPTER 7: ACCESS USING RADIUS
This command forces the
authentication period on port #1
every 5 minutes; all other ports are
force authenticated every hour as
indicated by the
command below.
MULTILINK ML810 MANAGED EDGE SWITCH – INSTRUCTION MANUAL
show-port reauth