GE Multilink ML810 Instruction Manual page 218

CONFIGURING RSTP THROUGH THE COMMAND LINE INTERFACE
Configuring RSTP (continued)
RSTP Port Configuration
-------------------------------------------------------------------------------
Port# Type Priority Path Cost State
-------------------------------------------------------------------------------
01 TP(10/100) 128 2000000
02 TP(10/100) 128 200000
03 100MB Fiber 128 200000
04 100MB Fiber 128 200000
05 100MB Fiber 128 200000
06 100MB Fiber 128 200000
07 TP(10/100) 128 2000000
ML810(rstp)##forceversion rstp
Error: Force Version already set to Normal RSTP
ML810(rstp)##forceversion stp
ML810(rstp)##show-forceversion
Force Version : Force to STP only
ML810(rstp)##show stp config
RSTP CONFIGURATION
-----------------
Rapid STP/STP Enabled(Global) : YES
RSTP/STP Enabled Ports
Protocol : Force to STP only
Bridge ID : 80:00:00:20:06:2b:e1:55
Bridge Priority
Bridge Forward Delay
Bridge Hello Time
Bridge Max Age
Root Port : 0
Root Path Cost
13–10
Des. Bridge
Forwarding 80:00:00:20:06:2b:e1:55 00:01
Forwarding 80:00:00:20:06:2b:e1:55 00:02
Disabled
Disabled
Disabled
Disabled
Disabled
: 1,2,3,4,5,6,7
: 32768
: 15
: 02
: 20
: 0
CHAPTER 13: RAPID SPANNING TREE PROTOCOL
Des. Port
00:03
00:04
The
00:05
forceversion
used for compatibility with STP
00:06
devices. In this example, the switch is
forced to STP mode.
00:07
Using
operating using RSTP. Note the
stp config
the switch protocol is RSTP.
MULTILINK ML810 MANAGED EDGE SWITCH – INSTRUCTION MANUAL
capability can be
, the switch is now
forceversion
show
command also indicates