GE Multilink ML810 Instruction Manual page 107

Managed edge switch
Hide thumbs Also See for Multilink ML810:
Table of Contents

Advertisement

CHAPTER 5: IP ADDRESSING
MULTILINK ML810 MANAGED EDGE SWITCH – INSTRUCTION MANUAL
Syntax ping6 <IPv6 address> - pings an IPv6 station.
There is also a special command to ping the status of IPv6. That command is
Syntax show ipv6 - displays the IPv6 information.
To configure IPv6, the following sequence of commands can be used:
ML810#
ipconfig ?
ipconfig : Configures the system IP address, subnet mask and gateway
Usage
ipconfig [ip=<ipaddress>] [mask=<subnet-mask>] [dgw=<gateway>]
ML810#
ipconfig ip=fe80::220:6ff:fe25:ed80 mask=ffff:ffff:ffff:ffff::
Action Parameter Missing. "add" assumed.
IPv6 Parameters Set.
ML810#
show ipv6
IPv6 Address : fe80::220:6ff:fe25:ed80 mask : ffff:ffff:ffff:ffff::
ML810#
show ipconfig
IP Address : 192.168.5.5
Subnet Mask: 255.255.255.0
Gateway Address: 192.168.5.1
IPv6 Address: fe80::220:6ff:fe25:ed80 mask : ffff:ffff:ffff:ffff::
IPv6 Gateway: ::
ML810#
In addition to the commands listed above, the commands which support IPv6 addressing
are
Syntax ftp <IPv6 address> - ftp to an IPv6 station
Example –
ftp fe80::220:6ff:fe25:ed80
Syntax telnet <IPv6 address> - telnet to an IPv6 station
Example –
telnet fe80::220:6ff:fe25:ed80
Besides, if the end station supports IPv6 addressing (as most Linux and Windows systems
do), one can access the switch using the IPv6 addressing as shown in the example below
http://fe80::220:6ff:fe25:ed80
FIGURE 5–5: Configuring IPv6
IPV6
5–33

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents