A warning remains active until its cause is no longer present. Under certain circumstances operation of the motor may still be continued. Warning messages

may be critical, but are not necessarily so.

In the event of an alarm, the frequency converter will have tripped. Alarms must be reset to restart operation once their cause has been rectified.

This may be done in four ways:

By using the [RESET] control button on the LCP control panel.

Via a digital input with the "Reset" function.

Via serial communication/optional fieldbus.

By resetting automatically using the [Auto Reset] function, which is a default setting for VLT Automation VT Drive Drive. see par. 14-20

Mode

inVLT Automation VT Drive Programming Guide

NB!

After a manual reset using the [RESET] button on the LCP, the [AUTO ON] or [HAND ON] button must be pressed to restart the motor.

If an alarm cannot be reset, the reason may be that its cause has not been rectified, or the alarm is trip-locked (see also table on following page).

Alarms that are trip-locked offer additional protection, means that the mains supply must be switched off before the alarm can be reset. After being

switched back on, the frequency converter is no longer blocked and may be reset as described above once the cause has been rectified.

Alarms that are not trip-locked can also be reset using the automatic reset function in par. 14-20

If a warning and alarm is marked against a code in the table on the following page, this means that either a warning occurs before an alarm, or it can

be specified whether it is a warning or an alarm that is to be displayed for a given fault.

This is possible, for instance, in par. 1-90

Motor Thermal Protection

flash on the frequency converter. Once the problem has been rectified, only the alarm continues flashing.

MG.20.X1.22 - VLT

Remote Site Products - 1-888-532-2706 - www.remotesiteproducts.com

http://www.remotesiteproducts.com/p-20783-Danfoss-131X8145-VLT-Automation-VT-Drive-VFD-FC322-460V-.5-HP.aspx

8 Troubleshooting

Reset Mode

(Warning: automatic wake-up is possible!)

. After an alarm or trip, the motor carries on coasting, and the alarm and warning

is a registered Danfoss trademark