Table of Contents
Advertisement
5 How to Install
5
PC Software - MCT 10
All drives are equipped with a serial communication port. We provide a PC tool for communication between PC and frequency converter, VLT Motion
Control Tool MCT 10 Set-up Software.
MCT 10 Set-up Software
MCT 10 has been designed as an easy to use interactive tool for setting parameters in our frequency converters.
The MCT 10 Set-up Software will be useful for:
•
Planning a communication network off-line. MCT 10 contains a complete frequency converter database
•
Commissioning frequency converters on line
•
Saving settings for all frequency converters
•
Replacing a drive in a network
•
Expanding an existing network
•
Future developed drives will be supported
MCT 10
Set-up Software support Profibus DP-V1 via a Master class 2 connection. It makes it possible to on line read/write parameters in a frequency converter
via the Profibus network. This will eliminate the need for an extra communication network.
Save Drive Settings:
1.
Connect a PC to the unit via USB com port
2.
Open MCT 10 Set-up Software
3.
Choose "Read from drive"
4.
Choose "Save as"
All parameters are now stored in the PC.
Load Drive Settings:
1.
Connect a PC to the unit via USB com port
2.
Open MCT 10 Set-up software
180
MG.20.X1.22 - VLT
Remote Site Products - 1-888-532-2706 - www.remotesiteproducts.com
http://www.remotesiteproducts.com/p-20783-Danfoss-131X8145-VLT-Automation-VT-Drive-VFD-FC322-460V-.5-HP.aspx
Automation VT Drive FC322 Design Guide
®
is a registered Danfoss trademark
Advertisement
Table of Contents
