Table of Contents
Advertisement
5 How to Install
5.3.10 Control Cable Terminals
To mount the cable to the terminal:
1.
Strip isolation of 9-10 mm
2.
Insert a screw driver
1)
in the square hole.
3.
Insert the cable in the adjacent circular hole.
4.
Remove the screw driver. The cable is now mounted to the ter-
minal.
To remove the cable from the terminal:
1.
Insert a screw driver
1)
in the square hole.
2.
Pull out the cable.
1)
Max. 0.4 x 2.5 mm
5
152
MG.20.X1.22 - VLT
Remote Site Products - 1-888-532-2706 - www.remotesiteproducts.com
http://www.remotesiteproducts.com/p-20783-Danfoss-131X8145-VLT-Automation-VT-Drive-VFD-FC322-460V-.5-HP.aspx
Automation VT Drive FC322 Design Guide
1.
3.
2.
®
is a registered Danfoss trademark
Advertisement
Table of Contents
