Data Matrix Length Control; Data Matrix Set Length 1 - Wasp WDI4600 Product Reference Manual

Data Matrix

Data Matrix Length Control

This feature specifies either variable length decoding or fixed length decoding for this
symbology.
Variable Length:
Fixed Length:
DEFAULT
$CDMLC01(CR)
Data Matrix Length Control = Fixed Length
Data Matrix
Specifies one of the barcode lengths for
label length if in
Characters can be set from 0001 to 3,116 characters in increments of 0001 (pad with zeroes).
See page 217
$CDML1
Select Data Matrix Length 1 Setting
Make a mistake? Scan the CANCEL barcode to abort and
not save the entry string. You can then start again at the
beginning.
Product Reference Guide
For variable length decoding, a minimum and maximum length may be set.
For fixed length decoding, two different lengths may be set.
Set Length 1
Variable Length Mode, or the first fixed length if in Fixed Length Mode.
for detailed instructions on setting this feature.
0001 = Length 1 is 1 Character
DEFAULT
Enter/Exit Programming Mode
$CDMLC00(CR)
Data Matrix Length Control = Variable Length
Data Matrix Length Control. Length 1 is the minimum
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE barcode above, then the barcode at
left followed by the digits from the Alphanumeric char-
Appendix D, Keypad
acters in
desired character(s). End by scanning the ENTER/EXIT
barcode again.
~
CANCEL
representing your
181