Setup
Customizing Configuration Settings
Configure Interface Settings
If after scanning the interface barcode from the previous table, your installation requires you to
select options to further customize your reader, turn to the appropriate section for your interface
type in
•
•
•
Global Interface Features
See "
Global Interface Features" on page 17
Configuring Other Features
If your installation requires different programming than the standard factory default settings,
the following sections of this manual allow configuration of non-interface-specific settings you
might require:
Reading Parameters
indicators and other universal settings.
1D Symbologies
settings allow you to enable/disable symbologies, set label lengths, require check digit, etc.
Software Version Transmission
The software version of the device can be transmitted over the RS-232 and Keyboard interfaces
by scanning the following label.
12
"Configuration Parameters" starting on page 15
"RS-232 Interface" on page 19
"RS-232/USB-Com Interfaces" on page 24
"Keyboard Settings" on page 31
:
Reading Parameters include programming for scanning, beeper and LED
:
Includes options concerning the barcode label types (symbologies). These
RevA
Customizing Configuration Settings
.
for settings configurable by all interface types.
Transmit Software Version
WDI4600