Resetting The Product Configuration To Defaults - Wasp WDI4600 Product Reference Manual

Customizing Configuration Settings

Resetting the Product Configuration to Defaults

Restore Custom Defaults
If you aren't sure what programming options are in your imager, or you've changed some
options and want to restore the Custom Default Configuration that may have been saved in the
scanner, scan the Restore Custom Default Configuration barcode below. This will restore the
custom configuration for the currently active interface.
$P,HA00,P(CR)
Restore Factory Configuration
If you want to restore the Factory Configuration for your imager, scan either the Restore USA
Factory Configuration barcode or the Restore EU Factory Configuration barcode below. Both
labels restore the scanner configuration to the factory settings, including the interface type. The
USA label restores Label IDs to those historically used in the USA. The EU label restores Label
IDs to those historically used in Europe. The Label ID sets for USA and EU are shown in the
"Label ID Control" section on page 49
The programming items listed in the following sections show the factory default settings for
each of the menu commands.
Product Reference Guide
Custom defaults are based on the interface type. Configure the imager
for the correct interface before scanning this label.
Restore Custom Default Configuration
of this manual.
$P,AE,P(CR)
Restore USA Factory Configuration
$P,Ae,P(CR)
Restore EU Factory Configuration
Setup
13