Flash On Time; Flash Off Time - Wasp WDI4600 Product Reference Manual

Reading Parameters

Flash On Time

This feature specifies the ON time for the indicator LED while in Flash Mode. The selectable
range is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in 100 millisecond increments. See
page 232
$CSNFN
Select Flash ON Time Setting
Make a mistake? Scan the CANCEL barcode to abort and
not save the entry string. You can then start again at the
beginning.

Flash Off Time

This feature specifies the OFF time for the indicator LED while in Flash Mode. The selectable
range is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in 100 millisecond increments. See
page 233
$CSNFF
Select Flash OFF Time Setting
Make a mistake? Scan the CANCEL barcode to abort and
not save the entry string. You can then start again at the
beginning.
Product Reference Guide
in "References" for detailed information on setting this feature.
DEFAULT
in "References" for detailed information on setting this feature.
DEFAULT
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE barcode above, then the barcode at
left followed by the digits from the Alphanumeric char-
Appendix D, Keypad
acters in
desired character(s). End by scanning the ENTER/EXIT
barcode again.
~
10 = Flash is ON for 1 Second
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE barcode above, then the barcode at
left followed by the digits from the Alphanumeric char-
Appendix D, Keypad
acters in
desired character(s). End by scanning the ENTER/EXIT
barcode again.
~
06 = Flash is OFF for 600ms
Enter/Exit Programming Mode
representing your
CANCEL
representing your
CANCEL
71