Wasp WDI4600 Product Reference Manual page 235

Table 36
STEP ACTION
1. Scan the ENTER/EXIT barcode
Determine placement of the
Label ID characters BEFORE or
AFTER with regard to scanned
2.
data using
Control" starting on page 49
Scan the barcode selecting the
symbology type you wish to
designate label ID characters
3. for using "Label ID Symbology
Selection • 1D
Symbologies" starting on page
50.
Custom Label ID example
4.
(desired characters):
Find hex equivalents from the
ASCII Chart(inside back
cover), then scan in these
digits/characters using the
barcodes in the section:
"Keypad" starting on page
5.
If you make a mistake before
the last character, scan the
CANCEL barcode to abort and
not save the entry string. You
can then start again at the
beginning.
6. Scan the ENTER/EXIT barcode
Scan the ENTER/EXIT barcode
7.
once again
Result:
Product Reference Guide
. Label ID Examples
Enable as Prefix
"Label ID
DataBar
Omnidirectional
D B *
261.
44 42 2A
DB*[barcode
data]
EXAMPLES
(Scanner enters Programming Mode)
Enable as Suffix Enable as Prefix
Code 39 Interleaved 2 of 5
= C 3 +
3D 43 33 2B
(Scanner exits Label ID entry)
(Scanner exits Programming Mode)
[barcode
+[barcode data]
data]=C3
Data Editing
Enable as Suffix
Code 32
P H
50 48
[barcode data]PH
225