Global Prefix/Suffix - Wasp WDI4600 Product Reference Manual

Enter/Exit Programming Mode

Global Prefix/Suffix

This option sets up to 20 characters each from the set of ASCII characters or any hex value from
00 to FF. The characters may be added as a prefix (in a position before the barcode data, also
called a header) and/or as a suffix (in a position following the barcode data, also called a footer).
See page 219
To configure this feature, scan the ENTER/EXIT PROGRAMMING MODE barcode above
to place the unit in Programming Mode, then the "Set Global Prefix" or "Set Global Suffix,"
barcode followed by the digits (in hex) from the Alphanumeric characters in
Keypad
are selected, scan the ENTER/EXIT barcode to terminate the string. Exit programming mode
by scanning the ENTER/EXIT barcode again.
$CLFSU
Set Global Suffix
Make a mistake? Scan the CANCEL barcode to abort and not
save the entry string. You can then start again at the begin-
ning.
44
for more detailed instructions on setting this feature.
representing your desired character(s). If less than the expected string of 20 characters
DEFAULT
$CLFPR
Set Global Prefix
~
No Global Prefix
Global Suffix = 0x0D (CR)
Data Format
Appendix D,
CANCEL
WDI4600