Error Codes - Wasp WDI4600 Product Reference Manual

Technical Specifications
Table 49
Programming Mode - The following indications ONLY occur when the reader is in Programming Mode.
Label Program- A valid programming label has
ming Mode Entry been scanned.
Label Program-
ming Mode A label has been rejected.
Rejection of Label
In cases where multiple labels
Label Program-
must be scanned to program one
ming Mode
feature, this indication acknowl-
Acceptance of
edges each portion as it is suc-
Partial Label
cessfully scanned.
Label Program- Configuration option(s) have
ming Mode been successfully programmed
Acceptance of via labels and the reader has
Programming exited Programming Mode.
Label Program-
ming Mode Can- Cancel label has been scanned.
cel Item Entry

Error Codes

Upon startup, if the reader sounds a long tone, this means the reader has not passed its
automatic Selftest and has entered FRU (Field Replaceable Unit) isolation mode. If the reader is
reset, the sequence will be repeated. The following table describes the LED flashes/beep codes
associated with an error found.
NUMBER OF LED
FLASHES/BEEPS
244
. Programming Mode Indications
1
2
6
12
15
LED blinks continuously
N/A
N/A
N/A
N/A
ERROR
Configuration
Interface PCB
Digital PCB
Imager
Accelerometer
Reader sounds four low fre-
quency beeps.
Reader sounds three times at
lowest frequency & current vol-
ume.
Reader sounds one short beep
at highest frequency & current
volume.
Reader sounds one high fre-
quency beep and 4 low fre-
quency beeps followed by reset
beeps.
Reader sounds two times at low
frequency and current volume.
CORRECTIVE ACTION
Contact Helpdesk for assis-
tance
WDI4600