Aiming Pointer; Aiming Duration Timer - Wasp WDI4600 Product Reference Manual

Enter/Exit Programming Mode

Aiming Pointer

Enables/disables the aiming pointer for all symbologies.
$CTAAP01(CR)
Aiming Pointer = Enable

Aiming Duration Timer

Specifies the frame of time the aiming pointer remains on after decoding a label, when in trigger
single mode.The range for this setting is from 1 to 255 seconds in 1-second increments. See
page 231
DEFAULT
LSTM
Set Aiming Duration Timer
Make a mistake? Scan the CANCEL barcode to abort and
not save the entry string. You can then start again at the
beginning.
72
in "References" for a description of this feature.
$CTAAP00(CR)
Aiming Pointer = Disable
DEFAULT
LSTM00
Aiming Off After Decoding
To configure, scan the ENTER/EXIT PROGRAMMING
MODE barcode above, then the barcode at left followed
by the digits from the Alphanumeric characters in
Appendix D, Keypad
representing your desired char-
acter(s). End by scanning the ENTER/EXIT barcode.
~
CANCEL
Reading Parameters
WDI4600