Wasp WDI4600 Product Reference Manual page 223

Enable Character
Specifies the value of the RS-232 host command used to enable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected.
To set this feature:
Determine the desired character or value.
not used (not available).
1. Determine the desired character or value.
2. Use the
3. Go to
4. Scan the barcode: SELECT ENABLE CHARACTER SETTING.
5. Scan the appropriate two alphanumeric characters from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
This completes the procedure. See
Table 31. Enable Character Setting Examples
STEP ACTION
1 Desired character/value
Hex equivalent from
2
Chart
3
4
Scan Two Characters From
5
Appendix D, Keypad
6
Product Reference Guide
Setting to previously defined characters such as XON, XOFF, or host com-
mands conflicts with normal operation of these characters. 8-bit data is
not recognized when the option
ASCII Chart on the inside back cover of this manual to find the hex equivalent
for the desired character/value.
page 30 and scan the ENTER/EXIT PROGRAMMING MODE barcode to enter
Programming Mode.
pad, that represent the desired character/value in step 2 above. The second character will
cause a two-beep indication.
Mode.
'e'
ASCII
0x65
Scan ENTER/EXIT PROGRAMMING MODE
Scan SELECT ENABLE CHARACTER VALUE SETTING
'6' and '5'
Scan ENTER/EXIT PROGRAMMING MODE
Data Bits
A setting of 0xFF indicates the Enable Character is
Table 31 for some examples of how to set this feature.
EXAMPLES
'}'
0x7D
'7' and 'D'
RS-232 Parameters
has been set as 7 Data Bits.
Appendix D, Key-
Enable Command
'E'
Not Used
0x45 0xFF
'4' and '5' 'F' AND 'F'
213