Stand Illumination Control; Motion Still Timeout - Wasp WDI4600 Product Reference Manual

Enter/Exit Programming Mode

Stand Illumination Control

Controls the illumination status while the reading mode is stand mode and the reader is
attempting to detect objects.
DEFAULT
$CSMIL01(CR)
Stand Illumination Control = ON

Motion Still Timeout

Motion Still Timeout specifies the waiting time after which no motions is detected. When no
motion is detected for period of time longer than the set Motion Still Timeout period, the
scanner assumes it is in a motionless condition. The selectable setting are from 500 to 25,500
milliseconds in 100 millisecond increments. The default is 2 seconds. This option relates to
such features and the Aimer On timing and Stand Mode Object Sense scanning with respect to
motion. See
$CMOTO/r
Select Motion Still Timeout Setting
Make a mistake? Scan the CANCEL barcode to abort and
not save the entry string. You can then start again at the
beginning.
DEFAULT
70
page 236 in "References" for detailed information on setting this feature.
14 = Motion Still Timeout for 2 seconds
$CSMIL00(CR)
Stand Illumination Control = OFF
$CSMIL02(CR)
Stand Illumination Control = Dim
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE barcode above, then the barcode at
left followed by the digits from the Alphanumeric char-
Appendix D, Keypad
acters in
desired character(s). End by scanning the ENTER/EXIT
barcode again.
~
CANCEL
Reading Parameters
representing your
WDI4600