Wasp WDI4600 Product Reference Manual page 234

References
Label ID: Set Individually Per Symbology
To configure a Label ID individually for a single symbology:
1. Go to
2. Select Label ID position as either BEFORE (Enable as Prefix) or AFTER (Enable as suf-
3. Scan a barcode to select the symbology for which you wish to configure a custom Label
4. Determine the desired character(s) (you may choose up to three) which will represent the
5. Turn to the
6. Scan the ENTER/EXIT barcode to exit Label ID entry.
7. Scan the ENTER/EXIT barcode once again to exit Programming Mode.
This completes the steps to configure a Label ID for a given symbology.
Figure 9. Label ID Position Options
224
page 49 and scan the ENTER/EXIT barcode.
fix) by scanning the appropriate barcode in the section "Label ID Control" on page 49.
Reference Figure 9 for Label ID positioning options if multiple identification features are
enabled.
ID from the section "Label ID Symbology Selection • 1D Symbologies" on page 50.
Label ID for the selected symbology.
ASCII Chart
hex digits associated with your choice of Label ID. For example, if you wish to select an
equal sign (=) as a Label ID, the chart indicates its associated hex characters as 3D. Turn to
"Keypad" starting on page 261
determined. For the example given, the characters '3' and 'D' would be scanned. More
examples of Label ID settings are provided in
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the begin-
ning.
Prefix Label ID
on the inside back cover of this manual and find the equivalent
and scan the barcodes representing the hex characters
Table
Aim ID Bar Code Data
OR
36.
Label ID Suffix
WDI4600