Wasp WDI4600 Product Reference Manual page 26

Enter/Exit Programming Mode
To program features:
1. Scan the ENTER/EXIT PROGRAMMING barcode, available at the top of each pro-
2. Scan the barcode to set the desired programming feature. You may need to cover unused
3. If additional input parameters are needed, go to
4. Complete the programming sequence by scanning the ENTER/EXIT PROGRAM-
For more detailed descriptions, programming information and examples for setting selected
configuration items, see
16
gramming page, when applicable.
barcodes on the page, and possibly the facing page, to ensure that the reader reads only the
barcode you intend to scan.
appropriate characters from the keypad.
Additional information about many features can be found in the "Refer-
ences" chapter.
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the begin-
ning.
MING barcode to exit Programming Mode.
References, starting on page
By default, the handheld will decode barcode labels only when they are
close to the center of the aiming pattern. This allows the handheld to accu-
rately target labels when they are placed close together, such as on a pick
sheet. See
Appendix D,
205.
Pick Mode, starting on page
Keypad, and scan the
68.
WDI4600