Wasp WDI4600 Product Reference Manual page 219

NAK Character
This setting specifies an ASCII character or hex value to be used as the NAK character. ASCII
characters or any hex value from 0 to 0xFF can be selected.
To set this feature:
1. Determine the desired character or value.
2. Use the
3. Go to
4. Scan the barcode: SELECT NAK CHARACTER SETTING.
5. Scan the appropriate two alphanumeric characters from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
This completes the procedure. See
Table 27. NAK Character Setting Examples
STEP ACTION
1 Desired Character/Value
Hex equivalent from
2
Chart
3
4
Scan Two Characters From
5
Appendix D, Keypad
6
Product Reference Guide
Setting to previously defined characters such as XON, XOFF, or host
commands conflicts with normal operation of these characters. 8-
bit data is not recognized when the option
as 7 Data Bits.
ASCII Chart on the inside back cover of this manual to find the hex equivalent
for the desired character/value.
page 27 and scan the ENTER/EXIT PROGRAMMING MODE barcode to enter
Programming Mode.
pad, that represent the desired character/value in step 1 above. The second character will
cause a two-beep indication.
Mode.
NAK
ASCII
0x15
Scan ENTER/EXIT PROGRAMMING MODE
Scan SELECT NAK CHARACTER SETTING
'1' and '5'
Scan ENTER/EXIT PROGRAMMING MODE
Table 27 for some examples of how to set this feature.
EXAMPLES
$
0x24
'2' and '4'
RS-232 Parameters
Data Bits
has been set
Appendix D, Key-
@ >
0x40 0x3E
'4' and '0' '3' AND 'E'
209