Getting Started; Set-Up Mode - AEMC CA7027 User Manual

4.3
The instrument is switched on and off using the green power button
the lower right side of the front panel. When the unit is first switched on it
will display the opening screen giving the software version, the currently
selected Vp (Velocity of Propagation), cable impedance and battery status
indicator.
4.4
1. Hold down the
enter set-up mode.
2. The following options can be configured:
• TDR or Tone Generation
• Set Vp to % (1 to 99%) or speed in micro-seconds (see § 4.8)
• Set cable impedance (Z) to 25, 50, 75 or 100Ω Twisted pair (T/P)
• Set measurement units to Feet or Meters
• Adjust the display contrast
• Disable/Enable Auto-off function
3. Press the
screen.
4. Press the
5. Press
NOTE: When the Fault Mapper Pro
the current set-up parameters.
Fault Mapper Pro
1.800.561.8187

Getting Started

Set-up Mode

TDR /
button, then press the
> TDR
Vp % VC
Vp=67%
T/P 100Ω
Meters
Contrast
Shutdown : 1 Minute
TEST /
button to move the line selector (>) down the
and buttons to change the setting of the line selected.
TDR /
again to save changes and exit set-up mode.
®
Model CA7027
www.
AEMC Instruments
Fault Mapper Pro
VX.X
® is turned off, it will retain
.com
on
TEST /
button to
information@itm.com
9