Area Of Interest Starting Pixel Csr - Basler L800k User Manual

Configuring the Camera

Area of Interest Starting Pixel CSR

Register Base Address: 0x1000
Field Name: Register Status
Description: The integer value in this field indicates the status of this control register:
Field Name: Starting Pixel
Description: Writing an integer value to this field sets the starting pixel for the area of interest (AOI) fea-
Field Name: Min
Description: Minimum allowed integer value for the starting pixel setting. This field is updated to reflect
Field Name: Max
Description: Maximum allowed integer value for the starting pixel setting. This field is updated to reflect
Field Name: Increment
Description: An integer value indicating the increment for the starting pixel setting.
4-34
0x00 = The register is not available
0x01 = The register is available. All related settings are OK
0x80 = A value in the register is set out of range
0x81 = The setting for the AOI starting pixel conflicts with the setting for the AOI length.
ture. The value for the starting pixel can normally range from 1 (0x0001) to 8159 (0x1FE0).
The actual available range may be limited by the way any related parameters are set.
If the value is set to 1, the starting pixel in the AOI will be pixel 1. If the value is set to 3, the
starting pixel in the AOI will be pixel 3. Etc.
(The AOI Starting Pixel must be set to an odd number, i.e., 1, 3, 5, 7, 9, etc.)
The 2 bytes in this field are interpreted as follows:
Byte 1 = Low byte of the starting pixel value
Byte 2 = High byte of the starting pixel value
See Section 3.7 for more information about the AOI feature.
limitations caused by the way any related features are set.
The 2 bytes in this field are interpreted as follows:
Byte 1 = Low byte of the min value
Byte 2 = High byte of the min value
limitations caused by the way any related features are set.
The 2 bytes in this field are interpreted as follows:
Byte 1 = Low byte of the max value
Byte 2 = High byte of the max value
The 2 bytes in this field are interpreted as follows:
Byte 1 = Low byte of the max value
Byte 2 = High byte of the max value
Draft
Offset: 0x0000
Offset: 0x0001
Offset: 0x0003
Offset: 0x0005
Offset: 0x0007
Size: 1 Byte Type: Read only
Size: 2 Bytes Type: Read / Write
Size: 2 Bytes Type: Read only
Size: 2 Bytes Type: Read only
Size: 2 Bytes Type: Read only
BASLER L800
k