Table of Contents
Advertisement
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
THE MAIN PARTS
4
6
7
8
9
1 Bobbin winder (Page 13)
This winds the thread onto the bobbin for use as the
lower thread.
2 Spool pin (Page 13, 17)
This holds the spool of thread.
3 Thread guide (Page 13, 17)
This is used when winding the thread onto the
bobbin and then threading the machine.
4 Thread take-up lever (Page 18)
5 Hole for extra spool pin (Page 26)
This holds a second spool of thread for sewing with
the twin needle.
6 Upper tension-control dial (Page 27)
This controls the tension of the upper thread.
7 Thread cutter (Page 24)
Pass the threads through the thread cutter to cut them.
8 Needle threader (Page 19)
(This is only available on certain models.)
9 Quick-set bobbin (Page 16, 21)
(This is only available on certain models.)
0 Flat bed attachment with accessory compartment
(Page 6)
A Presser foot (Page 10)
B Reverse sewing lever (Page 12)
Push this lever to stitch in the reverse direction.
C Buttonhole fine-adjustment screw (Page 34)
D Pattern selection dial (Page 11)
Rotate the dial in either direction to choose the
stitch you want.
E Handwheel
Used to manually raise and lower the needle.
F Air vent
The air vent allows the air surrounding the motor to
circulate.
Do not cover the air vent while the machine is
being used.
1
2
3
A
5
D
E
C
B
F
K
G
G Main power and sewing light switch (Page 8)
You can turn the main power and sewing light
switch on and off.
H Foot controller jack / socket (Page 7)
Plug in the foot controller plug and connect the
machine to the power supply.
I Presser foot lever (Page 17)
Used to raise and lower the presser foot.
J Handle
Carry the machine by its handle when transporting.
K Foot controller (Page 8)
You can use this to control the sewing speed, and to
start and stop sewing.
Foot Controller:
Model KD-1902 for 110-120V area
KD-1902 for 110-127V area (Brazil only)
Model KD-2902 for 220-240V area
The foot controller part code differs depending on the
country or region. Contact your Brother dealer or the
nearest authorized Brother Service Center.
Flat bed attachment
The accessories can be stored in a compartment inside
the flat bed attachment.
Slide the flat bed attachment to the left to
1
open it.
1 Flat bed attachment
2 Storage compartment
J
I
H
1
2
1
6
Advertisement
Table of Contents
