Table of Contents
Advertisement
To remove the bezel assembly, complete the following steps.
Step 1.
Before you begin, read "Safety" on page iii and "Installation guidelines" on page 37.
Step 2.
If the blade server is installed in a BladeCenter unit, remove it (see "Removing the blade server from
the BladeCenter unit" on page 39 for instructions).
Step 3.
Open the blade server cover (see "Removing the blade server cover" on page 72 for instructions).
Step 4.
If an optional expansion unit is installed, remove it (see "Removing an optional expansion unit" on
page 58).
Step 5.
Carefully lay the blade server on a flat, static-protective surface, with the cover side down.
Step 6.
Locate the four screws that secure the bezel assembly to the blade server base assembly.
Step 7.
Use a screwdriver to remove the four screws that secure the bezel assembly to the blade server
base assembly. Save the screws in a safe place. It is recommended to use the same screws when
installing the bezel assembly.
Step 8.
While holding the bezel assembly and the blade server, rotate the blade server so that the cover
side is up.
Step 9.
Lift the bezel assembly away from the blade server.
Step 10. If you are instructed to return the bezel assembly, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.
Installing the bezel assembly
Use this information to install a bezel assembly in the blade server.
Notes:
1. The following illustration shows how to install a bezel assembly in a blade server.
2. The illustrations in this document might differ slightly from your hardware.
To install the bezel assembly, complete the following steps.
.
Chapter 4
Removing and replacing blade server components
75
Advertisement
Table of Contents
