Table of Contents
Advertisement
Select this choice to view the system management network interface port, the IMM2 MAC address,
the current IMM2 IP address, and host name; define the static IMM2 IP address, subnet mask, and
gateway address; specify whether to use the static IP address or have DHCP assign the IMM2 IP
address; save the network changes.
– Restore IMM to Defaults
Select this choice to restore the IMM2 to the default settings. The IMM2 controller restarts after you
restore the settings.
– Reset IMM
Select this choice to restart the IMM2 controller.
– Recovery
Select this choice to view or change recovery settings.
– Storage
Select this choice to view or change the storage device settings.
– Network
Select this choice to view or change the network device options, such as iSCSI.
– Driver Health
Select this choice to view the status of the controllers installed in the blade server.
• Date and Time
Select this choice to set the date and time in the server, in 24-hour format (hour:minute:second).
This choice is on the full UEFI Setup Utility menu only.
• Start Options
Select this choice to view or change the start options, including the startup sequence, keyboard NumLock
state, PXE boot option, and PCI device boot priority. Changes in the startup options take effect when you
start the server.
The startup sequence specifies the order in which the server checks devices to find a boot record. The
server starts from the first boot record that it finds. If the server has Wake on LAN hardware and software
and the operating system supports Wake on LAN functions, you can specify a startup sequence for the
Wake on LAN functions. For example, you can define a startup sequence that checks for a disc in the CD-
RW/DVD drive, then checks the hard disk drive, and then checks a network adapter.
This choice is on the full UEFI Setup Utility menu only.
• Boot Manager
Select this choice to view, add, delete, or change the device boot priority, boot from a file, select a one-
time boot, or reset the boot order to the default setting.
• System Event Logs
Select this choice to access the System Event Manager, where you can view the POST event log and the
system-event log.
The POST event log contains the three most recent error codes and messages that were generated during
POST.
The system-event log contains POST and system management interrupt (SMI) events and all events that
are generated by the baseboard management controller that is embedded in the integrated management
module.
Important: If the system-error LED on the front of the blade server is lit but there are no other error
indications, clear the system-event log. Also, after you complete a repair or correct an error, clear the
system-event log to turn off the system-error LED on the front of the blade server.
– POST Event Viewer
14
BladeCenter HS23 Blade ServerProblem Determination and Service Guide
Advertisement
Table of Contents
