Table of Contents
Advertisement
• If using Installation Tool A, twist the handle on the microprocessor tool assembly
counterclockwise to the open position to insert the microprocessor into the socket, and lift
the installation tool out of the socket.
• If using Installation Tool B, twist the handle of the installation tool assembly
counterclockwise until the microprocessor is inserted into the socket, and lift the installation
tool out of the socket. The following illustration shows the tool handle in the open position.
Figure 5. Installation Tool B
Figure 6. Installation tool handle adjustment
Attention:
• Do not press the microprocessor into the socket.
• Do not touch exposed pins of the microprocessor socket.
• Make sure that the microprocessor is oriented and aligned correctly in the socket before
you try to close the microprocessor retainer.
• Do not touch the thermal material on the bottom of the heat sink or on top of the
microprocessor. Touching the thermal material will contaminate it.
Step 5.
Close the microprocessor socket release levers and retainer:
68
BladeCenter HS23 Blade ServerProblem Determination and Service Guide
E5-x6xx
E5-x6xx v2
Advertisement
Table of Contents
