Lenovo BladeCenter HS23 7875 Problem Determination And Service Manual page 112

• Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
• See Chapter 3 "Parts listing" on page 29 to determine which components are consumable, structural, or CRU
parts.
• If an action step is preceded by "(Trained technician only)," that step must be performed only by a trained
technician.
Diagnostic
Message
code
S.2011001 [S.2011001] An
Uncorrected PCIe Error
has Occurred at Bus %
Device % Function %.
The Vendor ID for the
device is % and the
Device ID is %.
S.2018001 [S.2018001] An
Uncorrected PCIe Error
has Occurred at Bus %
Device % Function %.
The Vendor ID for the
device is % and the
Device ID is %.
96
BladeCenter HS23 Blade ServerProblem Determination and Service Guide
Description
PCI SERR Detected.
PCIe Uncorrected Error
Detected.
Action
1. Check the IBM support website for an
applicable retain tip or firmware update that
applies to this error.
2. Reseat the expansion cards (see "Removing
an I/O expansion card" on page 50 and
"Installing an I/O expansion card" on page
53).
3. Replace the following components one at a
time in the order shown, restarting the server
each time:
• Expansion cards (see "Removing an I/O
expansion card" on page 50 and
"Installing an I/O expansion card" on page
53).
• (Trained technician only) Replace the
system board (see "Removing the system-
board assembly" on page 71 and
"Installing the system-board assembly" on
page 71).
1. Check the IBM support website for an
applicable retain tip or firmware update that
applies to this error.
2. Reseat the expansion cards (see "Removing
an I/O expansion card" on page 50 and
"Installing an I/O expansion card" on page
53).
3. Replace the following components one at a
time in the order shown, restarting the server
each time:
• Expansion cards (see "Removing an I/O
expansion card" on page 50 and
"Installing an I/O expansion card" on page
53).
• (Trained technician only) Replace the
system board (see "Removing the system-
board assembly" on page 71 and
"Installing the system-board assembly" on
page 71).